Crossram Throttle Cable 1967-1969 Z28

Brand New, opened pkg, never used. 1 cable 1 retaining clip The Hugger Performance U00039 is a specialized reproduction throttle (accelerator) cable designed specifically for 1967–1969 Chevrolet Camaros equipped with the Crossram (2x4 dual-quad) intake manifold. While it is most famous for its use on the 1969 Z28 302 Crossram setup, it is technically the correct reproduction for any 1967–1969 Camaro running that specific off-road dual-carburetor intake. Fitment Details • Vehicle: 1967, 1968, and 1969 Chevrolet Camaro. • Engine/Induction: Specifically for the Crossram intake manifold (which was a dealer-installed or service-part option, primarily for Trans-Am racing). • Compatibility: This cable is designed to work with the 6-cylinder style accelerator pedal assembly. If your Camaro still has the factory V8 rod-style age, this cable will not fit without swapping to the cable-style pedal. Why This Specific Part? Because the Crossram manifold sits very low and the dual carburetors are positioned differently than a standard single 4-barrel, the traditional V8 mechanical age would not clear the manifold. Chevrolet engineers utilized the throttle cable from the inline-6 models to provide the necessary flexibility and reach. The U00039 is the modern high-quality reproduction of that specific solution. Key Complementary Parts: If you are installing this cable, you will typically also need: • Retainer Clip (M00504-R): To secure the cable to the mounting bracket. • Crossram Throttle Bracket: To hold the cable at the rear of the manifold. • Cable-Style Pedal Assembly: Required if converting from a standard rod-age V8. 1. Physical Verification (Measurements) If you are comparing this to an old cable or checking fitment, here are the exact specs for a correct Crossram cable: Feature Measurement / Description Total Cable Length ~19.5 inches (Inner wire, tip to tip) Outer Housing Length ~17.5 inches (Measured between the retainers) Firewall Fitting White or Black plastic Square Snap-In style Carburetor End Small steel eyelet or barrel (designed for a cotter pin or clip) Housing Material Black flexible vinyl/rubber over coiled steel. The U00039 is approx. 9 longer. Pick up Add $21.95 to ship to lower 48